Firstly put same measurements as shown ort page no. 7 till 5-6-0 and below that as follows
0 to 7 : Take three inches or maximum five or six Inches upwards as per choice.
6 to 8 Same as 0 to 7. But take It upwards as shown in the figure.
8 to 9 : Take one inch crosswise
5 to 10 : Take two inches crosswise.
7-9-10-4 : As shown in the figure. mark the outer armhole for both sides. (If marked one side inner & othe outer, armhole does not matter.) These sleeve can be made half I three forth or ful sleeves by marking gathers as shown in the fig.
2 Chuddidar sleeves / Bangle SleevesFor this type of sleeves take same measurements as we take for full sleevecs. But only take tight measure of wrist as there comes two hooks.
O to 1: Sleeve length
O to 2: Take three or three & half inch normally.
1 to 3: Half of sleeve round
2 to 4: Same armtlole depth which Is taken for kurta i.e. Oto.2
5- 6-0: Make a right angle.
5 to 6: Make three parts and give shape as we give for plain sleeves. If you want gathers on top (upper side), then mark or give shape as we TI give shape for sleeves having gathers.
1 to A: Take five to six inches downwards
3 to B: Take ftve to six inches downwards
B to C: Keep four inches for slit open.
For making the sleeve of this kind, instead of stitching near B or C, stitching should be done on the sides. Strips from B to C should be done and kept open ·for passlng the F hand. The stitching by the downward fold should b:e done 0
thereafter.
